Woodworking Shop Safety
10 Safety Tips to Post in Your Shop
1)
Think Before You Cut – The most powerful tool in your
shop is your brain, use it. Thinking your cuts and movements through
before acting can help save both fingers and scrapwood.
2)
Keep a Clean Shop – A cluttered shop is an accident
waiting to happen. Keeping your shop clean will help protect you, and
your tools, from tripping hazards.
3)
Avoid Distractions – Pay attention to your actions.
Looking up to watch the shop TV or visitor can result in your hand
contacting the blade. Always wait until you have completed your cut
before you take your eyes off the blade.
4)
Don’t Rush – Keep in mind that this is just a hobby and
take a break when you feel rushed or frustrated with a project.
Mistakes happen when we rush to complete a job.
5)
Don’t Force It – If your saw is resisting the cut, stop
and see what’s wrong. A misaligned rip fence or improperly seated
throat plate can sometimes cause a board to get stuck in mid cut.
Forcing the board in these situations may cause kickback or contact
with the blade. Take a moment to evaluate the situation and determine
the problem.
6)
Protect Yourself – Wearing the proper shop protection is
an important part of safe tool operation. Goggles, Ear Protection, and
Lung Protection should be used when operating tools. Use push sticks
when working close to the blade and make sure the tool's safety
features are in place.
7)
Let the Tool Stop – Giving the power tool time to wind
down after a cut is an often-overlooked safety mistake. Even without
power, the spinning blade can still do a lot of damage.
8)
Fumes and Dust – Solvent fumes and airborne dust can
present health and explosion hazards. Care should be taken to ensure a supply of
fresh air and use only explosion proof vent fans.
9)
Wear Appropriate Clothing – Loose clothing or hair can
get caught in power tools and cause severe injury.
10)
No Alcohol – Too many woodworkers have been injured
because Alcohol clouded their judgment. Avoid their mistakes and wait
until after you’re done in the shop.
|
