Step D - We are now going to
assemble the 2x4 base. Use 16d nails and assemble the 2x4 parts as
seen in the "Lumber Cut Diagram". Pay special attention to
overlapping the lumber as seen in the diagram. After you assemble
the base, use a 3/4" (or larger) spade bit to drill two holes in
both the "R SIDE" and "L SIDE" of
the base to allow moisture to escape.
Step E -
Attach the body to the base using six 1-5/8" galvanized deck
screws. Screw through the "BOTTOM" into the base making
sure to sink the screws slightly into the wood to protect your dog
from sharp edges.
Step F - Attach the "PORCH BOTTOM"
to the base using six 1-5/8" galvanized deck screws making sure
to sink the screws slightly into the wood.
Step G -
Attach "PORCH ROOF SIDE A" and "PORCH
ROOF SIDE B" to the "PORCH ROOF". Screw
through the roof and into the side pieces.
Step H - Attach
the "PORCH FASCIA" to the front of the "PORCH
ROOF"
Step I - Attach the "PORCH POSTS"
to the "PORCH ROOF"
Step J - Attach the
"PORCH ROOF" to the body of the doghouse by
screwing into the roof and roof sides from the inside of the
doghouse. Also screw through the "PORCH BOTTOM"
into the "PORCH POSTS" to secure them in place.
Step
K - Paint the doghouse using an exterior grade paint.
Note: The roof is not attached to the doghouse body. It sits on the
body and is removable for cleaning.
Congratulations!
Your dog now has a new home. We hope you enjoyed the plans. Please
let us know how the project went for you. We'd love to see a picture of
how you decorated the house! (see below)
